Product selling point:
1: Wide range of applications
2: stable performance
3: Small size
4: Simple to use
5: Control board driver combination optionalIllustrate:
Supply voltage: DC10V~30V (DC 12V 24V)
Drive current range: within 3A
Controller type: single axis stepper motor controller
Signal support: no trigger/NPN (normally open)
Adjustment method: end potentiometer adjustment
Applicable motor: within 3A, two-phase stepper motor
3A or above requires an external driver
Delay range: 0~999.9s
Applicable drive: Compatible with 99% of stepper/servo motor drives on the market
Speed range 0.1~999.9 Rpm
Pulse range: 1~99990 single pulses
Drive control combination module Weight: 170.7g
Drive control combination module Size: 138*77*21mm
Stepper Motor Controller Weight: 45.9g
Stepper motor controller size: 71*60*29mm
Drive module weight: 41.5g
Drive module size: 71*60*24mm
Function: There are 9 common functions by default, which can realize stepper motor jog, self-locking, limit, angle, pulse, speed, reciprocating cycle, delay control, etc. (see function description for details)
NOTE: Please use the power switch to power the drive. Power (voltage * current) is too small, it will affect the torque of the motor. Recommend 24V5A or 12V10A universal switching power supply
★Short press the No. 1 potentiometer to enter the function selection mode, after selecting the function, wait for three seconds to automatically save
In the function setting mode, turn the No. 2 potentiometer to adjust the intermittent time value of the motor forward and reverse rotation
After setting the function mode, turn the potentiometer ① to adjust the motor speed.
★Turn the No. 2 potentiometer to adjust the number of pulses: for example, in the case of 8 subdivisions, 1600 pulses are one circle, press one
The lower corner adjustment potentiometer decimal point 160.0 represents 16000 pulses, that is, 10 turns.External drive link mode:
Controller EN Connect Drive EN +
Controller DIR connection drive DR +
Controller PUL Connection Drive PUL +
Controller GND drives DIR- and EN- and PUL- to their negative polesPackage Included:
1* control board only/drive module only/drive control board shell combination optional