Description

Remote Control Distance:100-1000m( Ideal Distance WITHOUT Any Block and Signal Interfere,Could Rise or Fall 10%-90% in Real Situation )

1.Working Voltage: DC12V10%2.Current:Standby less than 10mA,Working less than 128mA3.Working Temperature: -10\'C+60\'C4.Receiver Frequency: 315MHz/433.92MHZ5.Receiving Sensitivity: -105dB6.Output State: Switching Value7.Max Load:10A Relay, Resistive load less than 8A,Inductive load less than 3A8.Receiver Board Size:70*50*18mm9.Case Size:75 * 55 * 30mmEncoding Type: Learning CodeAdd transmitter by the Learning Button on the receiverOutput State: It is adjusted by the Jumper on the Receiver Board,Momentary-----Jumper on 1 Pin or Take away the JumperToggle--------Jumper on "3&4"Latched-------Jumper on "1&2"Momentary-----Press the transmitter button A,the receiver relay A is ON; Release button A ,The receiver relay A is OFF ,The same as B/C/DToggle--------Press the transmitter button A For 1 time ,the receiver relay A is ON; Press button A again,The receiver relay A is OFF ,The same as B/C/DLatched------Press transmitter button A,the receiver relay A is ON,the relay B/C/D is OFFPress transmitter button B,the receiver relay B is ON,the relay A/C/D is OFFPress transmitter button C,the receiver relay C is ON,the relay A/B/D is OFFPress transmitter button D,the receiver relay D is ON,the relay A/B/C is OFFIt mean ,Latched only can keep 1CH ON,and it will ofen have 1CH is ONLearning Method:Input DC12V Power for the receiver,press the learning button ,Green LED indicator OFF,Then press transmitter ,the LED indicator flash fast,It mean learning successfully.Clearing Code:Keeping press the learning button 8 seconds until the LED indicator ON, It mean the code have been cleared successfully.

Package included:A : 1*receiver (with cover)

     1* transmitters(with battery)

B : 1*receiver (with cover)

     2* transmitters(with battery)

C : 1*receiver (with cover)

      3* transmitters(with battery)

D : 1*receiver (with cover)

      4* transmitters(with battery)