Overview:

The remote control switch with 30A relay, you can load high-power appliances, receiving the way for the learning type of single-chip decoding, you can learn more than one remote control, and each remote control all the keys can learn, each remote control can control multiple switches, Can also be a number of remote control to control a switch,simple and flexible combination of any combination of remote control Each button to learn different ways to work, to avoid the way through the cap to switch the output of the trouble, easy to use, suitable for multiple areas of multiple uses , The output switch signal, easy to install, convenient.

Use: mainly used in lamps, electric doors, windows, lifting equipment.Water pump, elevator control, security industry and agricultural watering and other long-range wireless remote control and other fields, with easy installation, the use of simple and safe and reliable.

1.Transmitter

Channel: 4CH

Remote Control Distance:20-1000 M  ( Ideal Distance without any block and signal interfere , it would rise and fall about 10%-90% with the block and signal interference.)

Encode: PT2262

Frequency:433MHz

Size:106.8mm×48mm×24.2mm

Power Supply:3.7V polymer lithium battery power( can use micro-USB data line to charge the battery)

Emission current: 30-50mA

Static current: less than 1uA

Transmitting power: + 16dB

Battery capacity: 400mA

Charging time: 2.5h

2.Receiver

Operating Voltage: DC12-48V

Operating Frequency: 315 MHZ / 433 MHZ

Operating Temperature: -40C ~ +80C

Receiver Sensitivity: -105dBm

Maximum load: 3000 watts, rated load 1500 watts

Learning code:jog/Non-Latched .inter-lock/Latched .self-lock /Self-Latched

PCB size : 122 mm * 87 mm * 17 mm

output method:

Press A (data bit 1000) key to learn, the controller jog;

Press B (data bit 0100) key to learn, controller interlock;

Press C (data bit 0010) key to learn, the controller self-locking;

Press the D (data bit 0001) key to learn, the controller (1,2) jog + (3,4) self-locking;

Remote control A (data bit 1000) control relay 1;

Remote control B (data bit 0100) control relay 2;

Remote control C (data bit 0010) control relay 3;

Remote control D (data bit 0001) control relay 4;

learning methods

Press the learning button for 3 seconds, the indicator light on (indicating that has entered the learning state), release the learning key, press any key on the remote control, the indicator light flashes three times after that learning success.

Note: The controller can learn fixed code / learning code and other 16 different encoding remote control, in order to clear the earliest out of the remote control.

Fourth, removal methods

Press and hold the learning key for about 8 seconds.The indicator light goes from long to flashing 5 times and then goes out, indicating the successful removal.pacote inclued:

A:

1 x Transmitter(with battery)

B:

1 x Receiver(with cover)

C:

1 x Receiver(with cover)

1 x Transmitter(with battery)

D:

1 x Receiver(with cover)

2 x Transmitter(with battery)