Description

Specifications:

Control Lights, TVs, Motors, Fans, Cameras, Video signals, Audio signals, electrically operated Doors/ Locks/ Windows.

1.Transmitter

Channel: 2CH

Remote Control Distance:20-1000 M  ( Ideal Distance without any block and signal interfere , it would rise and fall about 10%-90% with the block and signal interference.)

Encode: PT2262

Frequency:433MHz

Size:106.8mm×48mm×24.2mm

Power Supply:3.7V polymer lithium battery power( can use micro-USB data line to charge the battery)

Emission current: 30-50mA

Static current: less than 1uA

Transmitting power: + 16dB

Battery capacity: 400mA

Charging time: 2.5h

2.Receiver

Working Voltage: AC220V

Working Frequency : 315MHz/433MHZ

Receiver sensitivity: :-107 dBm

Working temperature : -40‘C - 80’C

Decode: Learning Code

Control Type: Toggle, Momentary, Latched

working/output way:

Through the sub circuit board behind the pad Pin1

, Pin2, Pin3,Pin4,different local to switch working way

1,Momentary  1  2  3 4 no connection

2,Toggle          1+2  3+4  connection

3,Latched        1+2  connection ，3  4  no connection

4,Momentary+Toggle     1  2  no connection， 3+4  connection

1)Toggle/Self-Lock:   Press->On;Press again->Off

Press one button for one time is working/ON .press the same button again is stop/OFF .(1 channel switch(receiver) need 1 button remote control (transmitter).

2)Latched/Inter-Lock:   Press->On;Press other button->Off

Press one button is working/ON ,press another button is stop/OFF .( 1 channel switch( receiver) need 2 buttons remote control (transmitter).

3)Momentary/Jog:   Press and hold->On;Release->Off

Keep pressing one button is working /ON.loosen your finger is stop/OFF .1 channel switch(receiver) need 1 button remote control (transmitter )

3.Learn code and Remove Code

Learn: input the 110V-220V to the receiver,press the learning button then the LED indicator ON.Then press key 1 and press key 2 on the transmitter.At last press the learning button again to finish learning.

Remove:keep pressing the learning button on the receiver about 8 seconds until the indicator turns off,it means the codes are cleared successfully.

pacote inclued:

A:

1x Transmitter(with battery)

B:

1x Receiver(with cover)

C:

1x Receiver(with cover)

1x Transmitter(with battery)

D:

1x Receiver(with cover)

2x Transmitter(with battery)