Operating frequency : 433.92MHz ;
Receiver sensitivity :-95dB;Encoding: Receiver Recording;Momentary / Latch / Toggle selectable (defult is Toggle , Latch Mode need 2 buttons handsender );Output mode : Relay switch;Receiver size: 62 * 35 * 22 mm;
Max load : 500W;
Advantage :
1: Receiver Mother board have a learning key , if the remote is lost , must buy EV1527 OR Pt2262 remotes to re-learn;
Work mode (programmable )singnal Inter-locking (Latch)singnal Self-locking (Toggle is defult )
singnal Non-locking (Momentary )
Work mode explanation:
Momentary------------Press the Transmitter button A, the receiver relay A is ON, release button A; the receiver relay A is OFF, the same as B/C/D ,Every channel is Independent ;
Toggle---------------Press transmitter button A for 1 time , the receiver relay A is ON, press button A again, the receiver relay A is OFF, the same as B/C/D. Every channel is Independent ;
Latched------------------
Press transmitter button A, the receiver relay A is ON, the relay B/C/D is OFF.
Press transmitter button B, the receiver relay B is ON, the relay A/C/D is OFF.
Press transmitter button C, the receiver relay C is ON, the relay A/B/D is OFF
Press transmitter button D, the receiver relay D is ON, the relay A/B/C is OFF.
Program steps :
1: keep pressing learning key on the receiver controller ,
LED turn on after 2 second , then turn off after 4 second, then the receiver controller enter programming state , but not release the finger , still keep pressing the learning button ,
LED blink once after 2 second , release the finger on learing key , it is Momentary mode ,
or still keep pressing learing key ,
LED blink twice after 2 second , release the finger on learing key , it is Toggle mode ,
or still keep pressing learing key ,
LED blink 3 times after 2 second , release the finger on learing key , it is Latch mode ,
Learning method and steps
Keep pressing learnig key on receiver controller board , LED turn on after 2 seconds , release the finger on learning key , press the key on remote , work state LED blink 3 times , it means learnig successfully ;
Clear the deposit information
Keep pressing learnig key on receiver controller board, LED turn on after 2 seconds , then turn off after 4 seconds , it means clearing successfully .
433M PT2262 Remote Control:
Technical Data :
Power supply : DC6V , 2 pcs CR2016 replacable .(This remote doesnot have a battery , Please buy in your local market );
Operating current: ≤ 18mA;
Oscillation mode: SAW resonator;
Modulation mode: ASK/OOK;
Operating frequency: 433.92MHZ ;
Encoding IC : PT2260 fixed code (compatiable for PT2262 PT2264 SC2260 SC2262);
Output power : 9dBm (8mW) ;
Data Rate : <10Kbps ;
RC Resistance : 4.7M ;
