Unction Introduction

After installation of this system, when the vehicle is started, the microwave sensors on both sides of the rear will send a microwave sounding signal backwards. When a vehicle in the blind area is detected to be approaching, the system will processes the reflected signal. When it confirms that there is an object approaching, it alerts driver by issuing the corresponding sound and light signals. 1.When the vehicle is approaching, the corresponding side of the LED lights will be lit to prompt the rear of the vehicle near. 2.When the LED is lit, if the driver turns on the corresponding turn signal, the LED will flash and the buzzer will sound to indicate that the turnaround is risky at this time. 3.After the vehicle is stopped, the system delays for 30s. When there are bicycles, electric cars, motorcycles, pedestrians and other vehicles near the vehicle, the system will light up and there is a risk of opening the doors. Please confirm the safety before opening the doors.

Wiring

Yellow line is connected with common battery, battery B + red line then ACC + Black line grounding - Turn lights connect to the positive of the corresponding lamp Other extension wire directly marked according to the mark

Installation requirements

The signal transmitting surface of the sensor can only penetrate the plastic bumper shell and can not penetrate the metal. The sensor may be affected by fluorescent light The sensor should be firmly fixed with a bracket or 3M glue without shaking. The sensor terminals are vertically downward and parallel outward 25 °