Description

Description：

Brand Name: Happymodel

Model: Mobula6 HDZERO

Frame wheelbase: 65mm

Weight: 23.5 gram without battery

Size: 80mm*80mm*50mm

Receiver option:

SPI ELRS 2.4GHz

SPI FRSKY 2.4GHz

Compatible with 1S Lipo battery or Lihv battery(Not include)

Battery Plug: PH2.0

Recommend 3.8v LiHV 1S 300mAh LiPo Battery

Flight controller SuperbeeF4 Lite ELRS/FRSKY

SPI ELRS version Firmware target: CrazybeeF4SX1280

SPI FRSKY version Firmware target: CrazybeeF4FR

MCU:STM32F411CEU6 (100MHz, 512K FLASH)

Sensor: MPU-6000 or ICM20689 or BMI270(SPI connection)

Power supply: 1S Lipo Lihv battery input (DC 2.8V~4.35V)

Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready

Built-in Betaflight OSD(SPI Control)

Built-in SPI Frsky/ExpressLRS receiver

Built-in 5V 1A BEC

Built-in voltage detection

Onboard 4in1 ESC

MCU upgraded to EFM8BB21

Power supply: 1S LiPo/LiPo HV (2.8v~4.35v)

Currents: 5A continuous peak 6A (5 seconds)

Support BLHeliSuite programmable

Factory firmware: O_H_5_REV16_8.HEX

Default protocol: DSHOT150/DSHOT300/DSHOT600

Onboard SPI ExpressLRS 2.4GHz Receiver

Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz

RF Frequency: 2.4GHz

Antenna plug: IPEX

Telemetry output Power: <12dBm

Receiver protocol: SPI ExpressLRS

Could bind with ELRS V2.0 firmware TX module

Onboard Frsky SPI D8 /D16 2.4GHz Receiver

SPI BUS receiver Frsky D8/D16 compatible

Compatible Non EU transmitter D8 model and EU-LBT(Frsky_x_lbt)

Channels: 8ch or 16ch

Failsafe support

No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m

Based on CC2500 RF module Compatible with Futaba S-FHSS , Redpine protocol

Motor

Mode: EX0802 19000KV

Configu-ration:9N12P

Stator Diamter:8mm

Stator Length:2mm

Shaft Diameter:Φ1mm

Motor Dimension(Dia.*Len):Φ10.5mm*14.9mm

Weight(g):1.7g

No.of Cells(Lipo):1S only

Propeller Gemfan 1210 Bi-blades

Weight:0.19g

Material: PC

Pitch:1 inch

Props Dia:30mm

Center Hole Dia:1mm

HDZero Nano Lite Camera

14x16x11mm

1.5gram

0.5 inch, up to 10650 mV/Lux-sec ultra-high sensitive CMos sensor

Excellent low light performance

Fov:

4:3: D:130° H:108° v:84°

16:9:D:122° H:108° V:65°

HDZero Whoop Lite VTX

1S Input

25mW/200mW RF Output-SmartAudio Support

25.5x25.5 M2 Soft Mounting- Antenna Retention

Removable Shielding Box- 32.5x32.5mm(29x29mm inner)

4.5grams/4mm Thickness (without shielding)

Package Included:

1* Happymodel Mobula6 HDZero 65mm frame+Canopy

SPI Receiver Option1: SuperbeeF4 Lite FC built-in ExpressLRS SPI RX

SPI Receiver Option2: SuperbeeF4 Lite FC built-in Frsky SPI RX

4*EX0802 KV19000 Unibell brushless motor

1*Gemfan 1210 31mm propeller(4cw+4ccw)

1*HDZero Nano Lite Camera

1*HDZero Whoop Lite VTX

1*Spare Canopy

1*Propeller disassemble tool

1*Screw driver