FAQ

Q: If i purchased this what else would i need for the set up ?

A: If you purchased this unit I would recommend the following steps. 1st, Determine the height you need and purchase a very strong post, or pole to mount it on. I suggest mounting the support base to the pipe by welding it to a short pipe that can be fitted inside the long pipe. Mount your support pole very securly in the ground, and make certain to use adequate guy wires to hold it securely. Since this unit comes with a controller, you need at least one 12 volt battery, and one inverter. The wires go from the wind turbine, to the controller, from the controller to the battery, and from the battery to the inverter (assuming you want 110 volt /220volt AC power). Make CERTAIN that you hook the controller to the battery first thing.

Q: Can the wiring for the wind generator be intergrated into my present solar wiring ?

A: Yes. you can ! You can feed your battery bank with the charge controller included. Both your solar and this charge controller will feed the same bank. It's the same principal if you add additional solar cells to your array that are of a different type, size, and need their own charge controller (or your own controller is maxed-out). Both can feed the same bank. For instance, in an RV setup, the charge controller feeds the house batteries directly. Yet the engine can be started and the alternator will charge the house batteries normally. No disconnect or other equipment is needed.