Pay Attentions to:

Dear friend, please check the following instructions before you buy; if you do not meet the conditions still to buy, we will not accept returns

Please confirm

Condition I: the original remote control may be used normally Condition II: know the transmission frequency of original remote control (referring to the following diagram) Condition III: IC of original remote control is 2260(PT2260,SC2260,LX2260,HX2260); 2262,(PT2262,SC2262,LX2262,HS2262,HX2262),PT2264,PT2240(LX2240),1527(EV1527,HS1527,HX1527),FP527,CS5211,SMC918,SMC926,AX5026,AX53263,AX53264,HT600,HT680,HT6207,HT6010,HT6012,HT6013,HT6014,HT12D, HT46F49E, PIC16F629,PIC16F630 and so on. 5026-2 5026-3 5026-4 FP527 HT12E or without code. IC model of original remote control is 2262 2260 1527 2240 and compatible IC It is unnecessary to consider vibration resistance and address code. The project may be compatible to vibration resistance and address code. only support static code, does not support dynamic code.

NOTE

Here's how to tell the frequency of the remote control and the code chip, as shown below(each remote control board has a silver-white sound table with round,rectangular, Square,etc.).Each remote control has a black chip on it, and the chip has a model with a clearly coded chip on it.)

Inapplicable

The inapplicable IC is HCS300 30 HCS301 and compatible rolling code It's very very important. Don't ingnore them.Don't simple think the frequeny is same then it can be copied.It's not true.

Specifications:

1.Operating frequency: 433.92MHz2. Number of channels: 43. Code: Fixed code4.Include: 1 x Remote Control (Battery and Keychain Include),1 x English Manual5.Distance: Up to 100 metersNote：If the received remote B button does not light up, don't worry, this is normal. You can clone directly.With this remote cloner you can clone all 433.92MHz fixed code key fobs. Some remotes that use this frequency are listed below. This is not a complete list! If your remote uses the 433.92MHZ frequency it will work with the remote duplicator

How to Program - it's easy!

Face to face copy your original remote controlStep:1:Clear the history code from duplicator1:Press button A and B continuously until LED flash 3 times2.Release button B (Keep pressing button A),and press button B Slowly for 3 times,LED flash3.Release button “A”,finish code clearance. Step 2,Copy code from original transmitter1. Put duplicator aside of original transmitter,as close as possible.2. Press and hold button A of original transmitter,then press and hold button A of duplicator until you see the duplicator’s LED flash3. Release both buttons,finish code copy,copy other button in same way.Button A = Lock buttonButton B = Unlock button

Include

1 x Remote Control1 x Battery1 x Keychain1 x English Manual