Description

ST-Link V2 Mini STM8 Simulator Download

Specifications

lInput voltage (USB): 5V

lOutput Voltages: 3.3V, 5V

lInterfaces: SWIM, SWD

lConnectors: USB, 10 pin (molex type)

lDimensions: 57mm x 20mm x 8mm[2.2in x 0.7in x 0.3in]

• The St Link V2 programmer supports STM8 and STM32 microcontrollers

• The module supports automatic firmware upgrades to ensure the maintenance of ST products. The factory firmware has been updated to the latest version V2.J17.S4.

• 2x5 headers 2.54 mm (0.1 in) apart, including cables (4 f-f jumper wires)

• USB 2.0 full speed compatible interface

lWARNING: STM32 chips run on 3.3V, most breakout boards will include a voltage regulator so it can be powered from USB, and STLink dongles will provide a3.3V VCC pin to power up the chip.

lDo not connect the board to the PC using USB while the chip is powered up usingthe ST-Link V2 programmer!

lConnect one or another but not both simultaneously. The ST-Link V2 dongle provides a 5V pin as well. It is not going to be used because the STM32 chips are not5V tolerant, the 3.3V pin has to be used only.