7.Max Load:10A Relay, Resistive load less than 8A,Inductive load less than 3A
Learning and removing method:
1 .There is a learning button on the control panel of touch switch, the button is used to learn and remove the code.
2 .Press and hold the learning button for three seconds.When the indicator light flashes,we enter the learning state. Press any key on the remote controller to emit signal, the light flashes two times and off .It means you learn it successfully.
3. Delete remote control method: hold down the learning button for about 8 seconds, the indicator light turns on to off, then the code you learned before will be deleted.
Wireless remote control
Note: 433mhz and 315 mhz are available ,315mhz will be sent out if there is no demand on frequency
Package includes:
1 X Remote Control Transmitter(Not including battery) (No retail package)
1 X Remote Receiver Module (Including shell)
Note：1. This distance is the theoretical distance without interference, and the actual application is reduced due to the interference of the use environment. Please estimate according to the marked 10%-30%. The closer the wall is, the closer the relative distance is! The distance problem is not a product quality issue, thank you for your cooperation!
2. The antenna of the receiver should be kept at a vertical angle of 90 degrees with the inductor. The receiver should be installed in a place where there is less space and shielding. Please try to keep away from the inductive load or strong electric magnetic environment to ensure the receiver receives good reception. The antenna can be pulled down to increase the receiving sensitivity in case of poor reception!
